- Home
- Solutions
- Products
- Automatic Tank Gauge Probes
Automatic Tank Gauge Probes
- Automatic Tank Gauge Consoles
Automatic Tank Gauge Consoles
- Leak Detection System
Leak Detection System
- Tank Monitoring Software
Tank Monitoring Software
- Tank Area Security Equipment
Tank Area Security Equipment
- Tank Gauging Optional Device
Tank Gauging Optional Device
- Automatic Tank Gauge Probes
- Support
- News
- About
- Distributor
- Contacts
Position:Home / Support / Service / ATGs Installation
HOT PRODUCT
Contact us
- Tel：+86-371-60301609
- Fax：+86-371-60301612
- E-mail：emily@windbelltek.com samuelzh@windbelltek.com
- Skype：ling66ling samuellead
- Add : No.9, Changchun Rd, High-tech Development Zone, Zhengzhou, China 450001
ATGs Installation
The installation quality of ATG system and its accessories have a close bearing on safety, service quality, measuring accuracy and lifetime.
In order to operate safely, please comply with this notice. If it is out of accord with local regulation, please install and operate according to local regulation.
We're here to help:
Easy ways to get the answers you need.
Probe installation
Notice
1. For probe is high-precision product, please handle gently during move and installation.
2. During installation, please keep vertical of probe, otherwise will affect the accuracy of measurement.
3. Don't draw-off communication cable of probe when installation.
Process
1. Take probe out of package box.
2. Record "Manufacturing Code" on nameplate of probe, later communication setting will use it.
3. Remove foam package of probe.
4. Install fixed plate at both ends of electric house.
5. Plug communication cable into the socket at top of electric house and screw it tightly.
6. Carefully put oil floater and water floater at the bottom of probe.
7. Put probe into oil tank carefully by two hands, then hold fixed plate and adjust probe to be vertical, installation position please see Fig. 6.
Accessories installation
Safety warning
1. Every accessory must be installed in order and the order cannot be reversed.
2. Explosion-proof isolation sealed tube joint must be full filled with explosion proof daub, to prevent oil gas enters into control house through protection steel pipe.
3. Cables must be tightly compressed by sealing element, to prevent the infiltration of oil and gas.
4. All accessories must be screwed tightly.
5. The explosion proof junction box shall be grounded reliably, and the section area of the grounding wire shall be more than 6mm2.
6. When fasten the riser pipe flange and the bland flange, do not forget the sheet copper.
Related downloads
CONTACT US
- Tel:+86-371-60301609
- Fax : +86-371-60301612
- E-mail:sales@windbelltek.com
Add:No.9, Changchun Rd, High-tech Development Zone, Zhengzhou, China 450001
Console installation
1. Look for convenient place on the wall in office, to install smart console.
2. Install the fixed plate of console tightly on the wall by expansion screw.
3. Hang console on the fixed plate reliably.
4. The PE of console should be connected to grounding reliably with more than 6 mm² multi-core copper soft cables.
5. Power supply AC220V.
Installation dimension drawing of console (Unit: mm)