Introduction

1. Input tank serial number, please refer to the tank setup.

2. Input relevant alarm values at O HH, O H, O LL, O L, Temp H, Temp L, W H, W HH.

OHH alarm indicates that the oil product is likely to overfill, stop filling now.

OH alarm indicates that the oil product level high, keep your eyes on filling.

OL alarm indicates that the fuel is not enough, please make purchase order.

OLL alarm indicates that nearly no fuel inside this tank, need to close this tank now.

WHH alarm indicates that too much water inside tank, need to remove water out.

3. Input probe ID, please ensure the right ID, each probe have the sole ID which same as the manufacturing code on probe nameplate, please record before install. 

4. If need to calibrate oil level and water level, please measure the oil level and water level by dip stick, input the measured value in O value and W value, console program will automatically calculate the result and display on O offset and W offset.  Please note that all the unit is mm.

Note:

1. Please do not forget to save above information after input. 

2. If you want to delete one of the probes, click the relevant tank at left table, click “Delete” button is ok.